Snow Melting Thermal Blanket Could Prevent Melt Contamination
News Feb 15, 2018 | Original Story from the American Chemical Society.
Removing snow piled high in parking lots and along roadsides could soon be a far less tedious task. In a study appearing in ACS’ journal Langmuir, scientists report that they have tested sunlight-absorbing thermal blankets capable of melting snow three times faster than it would on its own. They say the blankets could slash snow-removal costs and reduce the risk of environmental contamination caused by soot and other products used to melt the white stuff.
Fresh snow reflects most of the sunlight shining on it, as well as much of the heat from those rays, back into the air. As a result, huge heaps of plowed snow can linger for weeks, even when the air is above freezing. Most cities in snow-prone regions either haul it to disposal sites or use gas-powered heaters to melt it. Both of these approaches are labor-intensive, time-consuming and costly. Depositing soot on fallen snow is an ancient, but effective way to increase sunlight absorption and speed up melting. However, soot, antifreeze and other commercial melting products can contaminate water and soil. Jonathan B. Boreyko and colleagues sought to find a more environmentally friendly way to melt snow using a new type of thin, conductive and thermally absorbent metal blanket.
The researchers created three types of these blankets made with an aluminum alloy. Two were coated with black enamel or black silicon-based spray paint that readily absorbed sunlight. The third blanket was bare aluminum, which reflected sunlight about as well as snow. In laboratory experiments, each of the blankets was draped over a pile of man-made snow stored in a refrigerated container. Then, the blanketed piles plus a pile of uncovered snow were exposed to a high-intensity lamp, which simulated sunlight. Snow under the bare aluminum blanket melted at about the same rate as uncovered snow. However, both of the blankets coated in black paint accelerated melting by about 300 percent, as measured by water runoff. The researchers conclude that these absorptive blankets could be used to quickly melt snowbanks in parking lots, driveways or roadsides without using heaters, soot or chemicals.
This article has been republished from materials provided by the American Chemical Society. Note: material may have been edited for length and content. For further information, please contact the cited source.
Thermally Absorptive Blankets for Highly Efficient Snowbank Melting. Owen L. Hansen, Andrew B. Sheen, Kristen M. Swedberg, Karl W. Vitale, Sarah M. Wray, Matthew D. Fox, and Jonathan B. Boreyko. Langmuir, Just Accepted Manuscript, DOI: 10.1021/acs.langmuir.7b03182.
Bloodstains at Crime Scenes Can Now be Used to Determine Age of SuspectNews
A new blood test, which could be performed at a crime scene, could help determine the age of a suspect or victim within just an hour.
This Seed Could Bring Clean Water to MillionsNews
Biomedical Engineering and Chemical Engineering Professors Bob Tilton and Todd Przybycien recently co-authored a paper with Ph.D. students Brittany Nordmark and Toni Bechtel, and alumnus John Riley, further refining a process that could soon help provide clean water to many in water-scarce regions. The process, created by Tilton’s former student and co-author Stephanie Velegol, uses sand and plant materials readily available in many developing nations to create a cheap and effective water filtration medium, termed “f-sand.”READ MORE
The Friedrich Schiller University Jena Partners with ACD/Labs to Advance its Analytical Data Management StrategyNews
Implementation of ACD/Spectrus as an analytical data management system helps researchers and students streamline NMR and MS data processing, interpretation, collaboration, and training.READ MORE