Post Purification Sample Handling
Complete the form below to unlock access to ALL audio articles.
Genevac has developed a suite of proprietary technological solutions to facilitate post purification sample handling, including reformatting. For labs undertaking purification using Normal Phase HPLC, SFC or Flash chromatography – removal of organic solvents can be simply, productively and safely carried out in a Genevac centrifugal evaporator (EZ-2, ROCKET, Rocket Synergy or HT Series III).
Where the nature of the sample being concentrated can lead to solvent bumping (e.g. natural products) - Genevac's DriPure® technology is proven to completely eliminate this troublesome and time-consuming problem.
The evaporation of aqueous acetonitrile (or methanol / ethanol) fractions resulting from
Reverse Phase HPLC is a widely carried out application on many Genevac evaporator systems. A multiple stage method has been developed for the EZ-2 evaporator to remove the organic solvent without freezing the water, remove the water, and then dry any remaining stubborn solvent.
Alternatively, the unique LyoSpeed™ fast lyophilisation method can be used in Genevac HT series evaporators to produce dry (solvent-free) powders from samples that previously could only be produced as gums and oils. Recent advances in condenser technology, in particular the high power -75°C cold trap, available on HT Series III and Rocket Synergy evaporators, has led to significant advances in lyophilisation success rates.
During post purification handling - samples typically need to be reformatted from fraction tubes or flasks, into a small vial for compound storage. For this specific time consuming task, Genevac developed SampleGenie™ technology. SampleGenie™ enables a large volume to be dried (or lyophilised) directly into a small storage vial in a fraction of the time taken by traditional evaporation methods that require you to reformat samples from a flask or multiple tubes into a vial.
